How To Set a Tamiya TEU101BK and an Airtronics MX3 Receiver

Posted this for DriftinRZ on DRC:
----------------------------------------------------------------------------------------------------------
Last night I took down my Mini Mutant which has this Rx/ESC combo.
1. The Bottom slot has the Steering Servo
2. The Second Slot has the 3 wire plug from the ESC
3. The third slot is for the 3rd channel (not used here)
BEC. The Top Slot is for the Power wire from the ESC. this is a 2 pin plug, but there are 3 slots, use the middle and right hand slots as shown,


Switch on the Radio (I'm using an MX3)
Select a model that you are not using elsewhere (1-5)
Set your throttle trims to neutral. I also had to set the throttle to reverse, but that was because I had used these electronics on another car before.
Switch on the ESC (I have located mine under hte car)
Press the red SET button with something non-conductive (like a piece of plastic sprue) The ESC should start to beep and the LED should flash on and off repeatedly.

Pull the throttle to max accelaration, and press the Set button again.
LED should flash like this:

when the ESC flashes like this , forward is set, and you need to press and hold reverse on the Transmitter then press the set button again. ESC will then stop beeping and your ESC is set!

Any questions, let me know!